Orbit Electronics

KBPC3510 
Bridge Rectifier Single Phase Standard 1 kV Through Hole KBPC
BRIDGE RECT 1PHASE 1KV 35A KBPC

SS14 SCHOTTKY DIODE MDD SMA / DO214AC
Diode 40 V 1A Surface Mount DO-214AC (SMA)
The SS14 Diode is a SMD version of 1N5819 Diode. It is a SMD High Power Schottky Rectifier diode. It has voltage drop of only 0.5 V and a high forward current of 1A. And it has High surge current capability of 30A.

90V 2PIN EPCOS GAS DISCHARGE TUBE 
Gas Discharge Tube 90 V 5000A (5kA) ±20% 2 Pole Through Hole
EPCOS - TDK Electronics
B88069X5010C102
GDT 90V 5KA 2 POLE THROUGH HOLE

LM393 Linear Integrated Circuit.

DUAL DIFFERENTIAL COMPARATOR

DESCRIPTION :
The UTC LM393 consists of two independent voltage comparators, designed specifically to operate from a single power supply over a wide voltage range.

FEATURES
Single or dual supply operation. 
Wide operating supply range (VCC=2V ~ 36V or ±1 ~ ±18V) 
Input common-mode voltage includes ground. 
Low supply current drain ICC=0.8mA (Typical). 
Low input bias current IBIAS=25nA (Typical). 
Output compatible with TTL, DTL, and CMOS logic system.

The TTP223 Touch Key Module is based on a touch-sensing IC (TTP223) capacitive touch switch module. A capacitive touch sensor module based on the dedicated TTP223 touch sensor IC. The module provides a single integrated touch sensing area of 11 x 10.5mm with a sensor range of ~5mm.

An onboard LED will give a visual indication of when the sensor is triggered. When triggered the output of the module will switch from its idle low state to high (default operation). Solder jumpers allow for reconfiguring its mode of operation to be either active low or toggle output.

TTP223 Capacitive Touch Sensor Module. The TTP223 is a touchpad detector IC replicating a single tactile button.

The TTP223 is a touchpad detector IC replicating a single tactile button. This touch detection IC is designed for replacing traditional direct button key with diverse pad size.

The H22B1, H22B2 and H22B3 consist of a gallium arsenide infrared emitting diode coupled with a silicon photodarlington in a  plastic housing. The packaging system is designed to optimize the mechanical resolution, coupling efficiency, ambient light rejection, cost and reliability. The gap in the housing provides a means of interrupting the  signal with an opaque material, switching the output from an “ON” to an “OFF” state